Contents: Removal ⤓ Installation ⤓
Anti-roll bar mounting elements
A and B are different types of stabilizers; 1 - anti-roll bar; 2 - stabilizer strut; 3 - bushing; 4 - mounting bracket.
Removal
Loosen the nuts and remove the anti-roll bar.
On later models, remove the nut at the top of the stabilizer bar and the cup and rubber bushing, then pull out the stabilizer bar and remove the rubber bushing and cup from it.
Loosen the nuts and remove the stabilizer bushing mounting bracket.
After removing the bushing, remove the anti-roll bar.
If necessary, loosen the three bolts and remove the stabilizer bar bracket.
Check the removed components for wear and damage.
Installation
Installation is carried out in reverse order, taking into account the following:
Since the positions of the right and left stabilizer bushing mounting brackets are different, install the stabilizer bar brackets in accordance with the figure.
Position the stabilizer so that the mark is on the right side.
Position the sleeve so that the colour mark protrudes approximately 5mm from the inside of the sleeve.
Check that the anti-roll bar rubber bush cups are positioned as shown in the figure, tighten the self-locking nut so that the value (A) is 3-5 mm.
Check the rear wheel alignment angles.