Connecting rod and piston — design description (Mitsubishi Colt 5)

The connecting rod and piston group is shown in Figure 3.53.

Figure 3.53, Connecting rod and piston group: 1 - Connecting rod lower cap nut; 2 - Lower connecting rod cover; 3 - Lower insert; 4 - Piston and connecting rod; 5 - Upper insert; 6 - Upper compression ring; 7 - Lower compression ring; 8 - Oil scraper ring; 9 - Piston pin; 10 - Piston; 11 - Connecting rod; 12 - Bolt.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Peter Ermakov

Share with friends:

◀ Previous

Colt 5: 4G1 engines since 1995

Next ▶

Replacing the valve stem guide bushing
Valve seat — inspection, treatment and replacement
Valve Stem Guide Bushing — Check
Valve spring — check
Valves — Checking

Piston rings — check
Connecting rod bearings — check
Crankshaft and cylinder block
Cylinder Block — Check
Main Bearing Shells — Installation

Similar materials for other Mitsubishi models