Power steering system — bleeding (Mitsubishi Colt 2)

1. If you disconnected the power steering hydraulic hoses during any operation, the system must be bled to remove all air from it and achieve the required steering assistance.

2. With the wheels aligned so that they point straight ahead, check the hydraulic fluid level in the pump reservoir and, if necessary, add the recommended type of hydraulic fluid (see the relevant chapter) so that its level rises to the Cold mark on the dipstick.

3. Start the engine and let it idle at high speed. Check the hydraulic fluid level again and add more fluid if necessary to bring the hydraulic fluid level to the Cold mark on the dipstick.

4. Bleed the power steering system by turning the wheels from side to side several times, but do not turn the wheels all the way. This will remove air from the hydraulic system. When bleeding air, make sure the hydraulic fluid reservoir on the pump is full.

5. Once the air has been bled from the system, set the wheels so that they point straight ahead and let the engine run for a few more minutes before turning it off.

6. Drive the vehicle and check the operation of the steering and the absence of extraneous noise when turning the steering wheel.

7. Check the hydraulic fluid level, it should be at the Hot mark on the dipstick while the engine is at normal operating temperature. Add hydraulic fluid if necessary (see the relevant chapter).